ADI公司的ADP1053是三路數字電源控制器,基于電壓模式PWM架構,能對三路單獨輸出提供控制,監(jiān)視和保護,其它兩路帶反饋控制,另一路帶固定占空比而未調整電壓,三路的開關頻率從50kHz到625kHz可單獨編程,適用于隔離和非隔離的DC/DC轉換器,AC/DC轉換器.本文介紹了ADP1053主要特性, 功能方框圖, 簡化應用電路圖以及兩種典型應用電路圖.

The ADP1053, based on a voltage mode PWM architecture, is a flexible, application dedicated digital controller designed for isolated and nonisolated dc-to-dc power supply applications. The ADP1053 enables highly efficient power supply design and facilitates the introduction of intelligent power management techniques to improve energy efficiency at a system level.

The ADP1053 provides control, monitoring, and protection of up to three independent channel outputs. The eight flexible PWM outputs can be configured as three independent channels: two regulated channels with feedback control plus one additional unregulated channel with a fixed duty cycle. The frequency of these three channels can be programmed individually from 50 kHz to 625 kHz; all channels can be synchronized internally or to an external signal.

All eight PWM outputs can also be assigned to enable a single-channel solution, which may be required in high power, high efficiency applications.

Features include differential voltage sensing, fast current sensing, flexible start-up sequencing and tracking, and synchronization between devices to reduce low frequency system noise. Protection and monitoring features include overcurrent protection (OCP), undervoltage protection (UVP), overvoltage protection (OVP), and overtemperature protection (OTP).

ADP1053主要特性:

Configurable 8-PWM engine with up to 3 channels

2 independent digitally controlled channel outputs

Voltage mode PWM control with 625 ps resolution

Remote voltage sensing on both channels

Programmable compensation filters

Voltage feedforward option

Flexible start-up sequencing and tracking

Switching frequency: 50 kHz to 625 kHz

Frequency synchronization

Independent channel protections: OVP and OCP

2 independent OTP circuits

Programmable fault protection sequence

Volt-second balance and dual-phase current balance for interleaved configurations

On-board EEPROM

PMBus-compliant

Graphical user interface (GUI) for ease of programming

Available in a 40-lead, 6 mm × 6 mm LFCSP

ADP1053應用:

AC-to-DC power supplies

Isolated dc-to-dc power supplies

Intermediate rail power supplies

Nonisolated dc-to-dc power converter

圖1.ADP1053功能方框圖

圖2.ADP1053簡化應用電路圖

圖3.ADP1053應用電路(1):降壓預調整+固定PWM全橋拓撲和同步整流

圖4.ADP1053應用電路(2):一路全橋整流兩路輸出
詳情請見:
http://www.analog.com/static/imported-files/data_sheets/ADP1053.pdf