</a>開關電源" title="開關電源">開關電源" title="開關電源">開關電源(SMPS)降壓控制器,2.5A SMPS降壓穩壓器和兩個低壓降(LDO)線性穩壓器控制器,和超低靜態電流的NCV861x一起能組成8輸出的無線系統或儀表盤電源解決方案.器件滿足ES−XW7T−1A278−AB測試脈沖G負載條件,VIN工作電壓9.0V-18.0V.本文介紹了NCV8855主要特性, 應用電路/方框圖, 汽車無線電系統框圖以及NCV8855評估板電路圖與材料清單.
The NCV8855 is a multiple output controller / regulator IC with an integrated high−side load switch. The NCV8855 addresses automotive radio system and instrument cluster power supply requirements. In addition to the high−side load switch, the NCV8855 includes a switch−mode power supply (SMPS) buck controller, a 2.5 A SMPS buck regulator and two low dropout (LDO) linear regulator controllers. The NCV8855 in combination with the ultra−low quiescent current NCV861x IC forms an eight−output automotive radio or instrument cluster power solution. The NCV8855 has an internally set switching frequency of 170 kHz, with a SYNC pin for external frequency synchronization.
The NCV8855 is intended to supply power to various loads, such as a tuner, CD logic, audio processor and CD / tape control within a car radio. The high−side switch can be used for a CD / tape mechanism or switching an electrically−powered antenna or display unit. In an instrument cluster application, the NCV8855 can be used to power graphics display, flash memory and CAN transceivers. In addition, the high−side switch can be used to limit power to a TFT display during a battery over−voltage condition.
NCV8855主要特性:
• < 1 uA Shutdown Current
• Meets ES−XW7T−1A278−AB Test Pulse G – Loaded Conditions
• VIN Operating Range 9.0 to 18.0 V
• 1 SMPS Controller with Adjustable Current Limit
• 1 SMPS Regulator with Internal 300 m NMOS Switch
• 2 LDO Controllers with Current Limit and Short Circuit Protection
• 1 High−side Load Switch with Internal 300 m NMOS FET
• Adjustable Output Voltage for All Controllers / Regulators
• 800 mV, +/-1% Reference Voltage
• System Enable Pin
• Single Enable Pin for Both LDO Controllers
• Independent Enable for High−side Load Switch
• Thermal Shutdown with Thermal Warning Indicator
• This is a Pb−Free Device
NCV8855應用:
• Automotive Radio
• Instrument Cluster, Driver Information System (DIS)
圖1. NCV8855應用電路/方框圖
圖2. NCV8855和NCV8612汽車無線電系統框圖
NCV8855評估板
圖3.評估板NCV8855BMNR2GEV外形圖
圖4.評估板NCV8855BMNR2GEV電路圖
評估板NCV8855BMNR2GEV材料清單:
詳情請見:
http://www.onsemi.cn/pub_link/Collateral/EVBUM2120-D.PDF
和
http://www.onsemi.cn/pub_link/Collateral/NCV8855BMNR2GEVB_SCHEMATIC.PDF
The NCV8855 is a multiple output controller / regulator IC with an integrated high−side load switch. The NCV8855 addresses automotive radio system and instrument cluster power supply requirements. In addition to the high−side load switch, the NCV8855 includes a switch−mode power supply (SMPS) buck controller, a 2.5 A SMPS buck regulator and two low dropout (LDO) linear regulator controllers. The NCV8855 in combination with the ultra−low quiescent current NCV861x IC forms an eight−output automotive radio or instrument cluster power solution. The NCV8855 has an internally set switching frequency of 170 kHz, with a SYNC pin for external frequency synchronization.
The NCV8855 is intended to supply power to various loads, such as a tuner, CD logic, audio processor and CD / tape control within a car radio. The high−side switch can be used for a CD / tape mechanism or switching an electrically−powered antenna or display unit. In an instrument cluster application, the NCV8855 can be used to power graphics display, flash memory and CAN transceivers. In addition, the high−side switch can be used to limit power to a TFT display during a battery over−voltage condition.
NCV8855主要特性:
• < 1 uA Shutdown Current
• Meets ES−XW7T−1A278−AB Test Pulse G – Loaded Conditions
• VIN Operating Range 9.0 to 18.0 V
• 1 SMPS Controller with Adjustable Current Limit
• 1 SMPS Regulator with Internal 300 m NMOS Switch
• 2 LDO Controllers with Current Limit and Short Circuit Protection
• 1 High−side Load Switch with Internal 300 m NMOS FET
• Adjustable Output Voltage for All Controllers / Regulators
• 800 mV, +/-1% Reference Voltage
• System Enable Pin
• Single Enable Pin for Both LDO Controllers
• Independent Enable for High−side Load Switch
• Thermal Shutdown with Thermal Warning Indicator
• This is a Pb−Free Device
NCV8855應用:
• Automotive Radio
• Instrument Cluster, Driver Information System (DIS)
圖1. NCV8855應用電路/方框圖
圖2. NCV8855和NCV8612汽車無線電系統框圖
NCV8855評估板
圖3.評估板NCV8855BMNR2GEV外形圖
圖4.評估板NCV8855BMNR2GEV電路圖
評估板NCV8855BMNR2GEV材料清單:
詳情請見:
http://www.onsemi.cn/pub_link/Collateral/EVBUM2120-D.PDF
和
http://www.onsemi.cn/pub_link/Collateral/NCV8855BMNR2GEVB_SCHEMATIC.PDF
本站內容除特別聲明的原創文章之外，轉載內容只為傳遞更多信息，并不代表本網站贊同其觀點。轉載的所有的文章、圖片、音/視頻文件等資料的版權歸版權所有權人所有。本站采用的非本站原創文章及圖片等內容無法一一聯系確認版權者。如涉及作品內容、版權和其它問題，請及時通過電子郵件或電話通知我們，以便迅速采取適當措施，避免給雙方造成不必要的經濟損失。聯系電話：010-82306118；郵箱：aet@chinaaet.com。